Passat V6-2.8L (ATQ) (2004)
Transmission Position Switch/Sensor: Service and Repair
Multi-Function Transmission Range (TR) Switch -F125-, Replacing
Multi-Function Transmission Range (TR) Switch -F125-, Replacing
Recommended special tools and equipment
-
V.A.G 1331 torque wrench (5 to 50 Nm)
Requirements
-
Selector lever must be in -P- position.
-
Parking brake must be engaged or else daylight driving lights will be switched on.
-
Ignition switched off.
Removing
-
Disconnect harness connector -2- to Multi-Function Transmission Range (TR) Switch -F125- (-1-).
Observe safety precautions.
-
Remove left transmission supports.
-
Unscrew mounting bolts and remove Multi-Function Transmission Range (TR) Switch -F125- (-1-) from shift rod.
Installing
NOTE:
-
For the sake of illustration, work procedure is shown with transmission removed.
-
Set Multi-Function Transmission Range (TR) Switch -F125- centered on shift rod. Risk of damage at switch terminals.