volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Relays and Fuses Inside Control Module Housing, In Plenum|Page 489 > < Relays and Fuses Inside Control Module Housing, In Plenum
Page 1
background image

Air Injection Pump Relay: Locations
Overview of Component Locations - ATW, AUG, AWM

Fuel injection, servicing 

Overview of component locations 

The following components are not displayed in the installation overview: 
Malfunction Indicator Lamp (MIL) -K83-
Electronic Power Control (EPC) Warning Lamp -K132-

-

Vehicles with engine code ATQ

Leak detection pump (LDP) -V144-

-

Under wheelhousing liner in rear left wheelhousing

Throttle Position (TP) Sensor -G79-

-

Vehicles with engine code ATQ

Clutch Vacuum Vent Valve Switch -F36-

-

Vehicles with engine code ATQ

Secondary Air Injection (AIR) Pump Relay -J299-

-

Component location, Fig. 1

Secondary Air Injection (AIR) Pump Motor -V101-.

The following components are displayed in the Component location overview: 

NOTE: 

-

Cylinder bank 1 is located on right side in direction of travel.

-

Cylinder bank 2 is located on left side in direction of travel.

1

4-pin harness connector
-

green

-

for Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) -G130- and Oxygen Sensor (O2S) Heater 1 (behind Three Way
Catalytic Converter (TWC)) -Z29-, cylinder bank 1

Relays and Fuses Inside Control Module Housing, In Plenum|Page 489 > < Relays and Fuses Inside Control Module Housing, In Plenum