Passat V6-2.8L (ATQ) (2004)
-
Press screwdriver in direction of arrow. In this case, clamp - will be pressed back and the catch - of the airbag unit will thereby disengage.
-
Turn steering wheel back 180 ° and disengage the second catch on the opposite side.
-
Turn steering wheel - to center position (wheels in straight-ahead position).
CAUTION: Electrostatic charges may result in involuntary deployment of the airbag. Therefore, the mechanic must be electrostatically
discharged before disconnecting ignition- and Ground (GND) wires. This is done e.g. by briefly grasping the chassis or door striker.
-
Disconnect harness connector from airbag unit.
Installing
-
Connect wiring harness of drivers side airbag.
-
Push airbag unit into steering wheel.
-
Check whether airbag unit is engaged in steering wheel completely.
-
Switch ignition on.
CAUTION: Make sure no one is in the vehicle.
-
Connect vehicle battery.
Vehicles with three-spoke steering wheel (except Passat W8)
Assembly overview