Passat V6-2.8L (ATQ) (2004)
/Page-2865017.png)
CAUTION: Electrostatic charges may result in involuntary deployment of the airbag. Therefore, the mechanic must be electrostatically
discharged before disconnecting ignition- and Ground (GND) wires. This is done e.g. by briefly grasping the chassis or door striker.
-
Disconnect wiring harness from head-level airbag - 1 -.
-
Remove bolt - 2 - (3 Nm).
-
Remove two bolts - 3 - (3 Nm).
-
Remove bolt - 4 - (3 Nm).
-
Remove bolt - 5 - (3 Nm).
-
Remove two bolts - 6 - (3 Nm).
-
Remove all clips for curtain airbag from body.
-
Remove head-level airbag from vehicle via rear lid.
NOTE: Securing clips - 7 -, securing bolts and guide - 8 - must be replaced before installing.
Installing
-
Installation is the reverse order of removal.
-
Switch ignition on.
CAUTION: Make sure no one is in the vehicle.
-
Connect vehicle battery.
Up To 09/2000
Component Locations --> 09.00 - Overview
