Passat V6-2.8L (ATQ) (2004)
/Page-288010.png)
-
Remove locking ring using special wrench for tank sensor 3087.
-
Carefully pull Fuel Level Sensor 2 -G169- slightly out of fuel tank opening.
-
Disconnect connector to Fuel Pump (FP) flange (in direction of travel, right) from inside of flange.
-
If necessary, siphon fuel from left chamber of fuel tank.
-
Reach into fuel tank and disengage catches - arrows - at bottom of the suction jet pump -2-
NOTE: Sensor is shown without fuel tank for the sake of illustration.
Installing Installation is performed in reverse order of removal. Note the following:
NOTE: Do not bend floater arm of Fuel Level Sensor 2 -G169- when installing.
