Passat V6-2.8L (ATQ) (2004)
/Page-2473002.png)
^
Check adjustment of switch - 1 - above clutch pedal as follows:
Switch - 1 - must contact clutch pedal - 4 -.
Maximum gap dimension - a - at switch - 1 - is 0.5 mm.
Securing clip - 2 - must contact mounting bracket - 3 -, maximum permitted distance - b - is 0.5 mm.
^
To adjust switch, hold securing clip - 2 - and turn switch.
When adjusting, clutch pedal must not be operated.
In order to assure sufficiently secure fitting, switch must not be installed more than once.
Clutch Pedal Switch F36, Removing and Installing, Adjusting (Clutch Pedal Switch Is Secured
Directly In Mounting Bracket)
Clutch Pedal Switch F36, removing and installing, adjusting (clutch pedal switch is secured directly in mounting bracket), 012/01W, 5 SPD.
M/T
In order to assure sufficiently secure fitting, clutch pedal switch must not be installed more than once.
Removing
^
Remove drivers side storage compartment.
^
Disconnect connector - 1 - at clutch pedal switch.
^
Pull clutch pedal switch - 2 - out of guide by rotating 45° toward left.
New clutch pedal switch, installing and adjusting
Note:
^
Check clutch pedal switch first.
^
Stop - A - must be before offset - B
^
Stop - C - is then directly beneath mounting hook
If this is not the case, plunger must not be pulled out.
Clutch slave cylinder will be destroyed when doing this.
Positions of stops - A - and - B - must be changed:
