Passat V6-2.8L (ATQ) (2004)
/Page-2601014.png)
^
The maximum adjustment range of the adjustment screw is 90° to the left or right of center.
^
Turn eccentric bolt until specification is obtained.
^
Tighten hex nut for eccentric bolt - 1 -.
^
Check toe values again.
Toe Constant "S", Adjusting
Toe constant "S", adjusting
^
Loosen nut - A -.
^
Unscrew bolt - B - approximately 4 mm.
^
Push toe rod joint downward onto stop.
^
Screw in adjustment bolt - B - until the exact specification is achieved.
^
Tighten hex nut - A - and check value.
Always use new hex nuts!
If the range of adjustment is not sufficient for adjusting toe-in curve, the wire ring - arrow - can be removed.
^
Tighten bolt - B -.
^
Lower vehicle to initial position again.
^
Screw threaded spindle down.
