Passat V6-2.8L (ATQ) (2004)
Front Steering Knuckle: Service and Repair
Wheel Bearing Housing, Removing and Installing
Wheel bearing housing, removing and installing
Special tools and equipment required
-
3287A Ball joint puller
-
VAG 1332 Torque wrench
Removing
-
Unbolt hex bolt for drive shaft. (Loosen only when vehicle is standing on wheels -danger of accident-).
-
Remove wheel.
-
Disconnect ABS speed sensor wiring out of retainer on brake caliper.
-
Remove bolts -1- for brake caliper and take off brake caliper.
-
Remove disc brake.
-
Secure brake caliper to body with wire.