Passat V6-2.8L (ATQ) (2004)
Power Steering Pump: Service and Repair
For 6-Cylinder 5-Valve Injection Engine, Assembly Overview
Power steering pump for 6-cylinder 5-valve injection engine, assembly overview
Note:
^
Replace seal rings
^
Do not reuse hydraulic fluid that has been drained.
^
Hydraulic fluid G 002 000
^
Quantity of oil in system approximately 1ltr.
1. Hex bolt, 10 Nm
2. Double bolt, 10 Nm
3. Ignition coil with bracket
4. Power steering pump
5. Clamp
^
Tension with V.A.G 1275
^
Always replace
6. Suction hose
7. Suction line
8. Internal hex bolt, 22 Nm
^
Securing bracket for power steering pump on crankcase
9. Internal hex bolt, 22 Nm
^
Securing power steering pump to power steering pump bracket
10. Sleeve, slotted
11. Internal hex bolt, 22 Nm
^
Securing bracket for power steering pump on crankcase
12. Internal hex bolt, 22 Nm
^
Securing power steering pump to power steering pump bracket
13. Power steering pump bracket
14. Internal hex bolt, 22 Nm
16. Belt drive pulley
^
When loosening and tightening counter-hold with V.A.G 1590 if necessary
16. Seal rings, 16 x 22
^
Always replace
17. Banjo bolt
^
=> Item - 24 -
18. Pressure line with hose
19. Hex bolt, 10 Nm