Passat V6-2.8L (ATQ) (2004)
^
Place selector lever in position "3".
^
First check whether a coded radio is installed. If this is the case obtain the anti-theft coding.
^
Disconnect battery Ground (GND) strap with ignition switched off.
^
Remove selector lever handle.
^
Remove center console and extension.
^
Remove steering wheel with airbag.
^
Remove steering column switches.
^
Turn ignition key to run position (ignition on).
^
Place selector lever in position "P".
^
Release interlock lever and pull locking cable - 1 - from ignition/starter switch.
^
Remove cover.
^
Unclip locking cable from securing spring at selector mechanism housing, slightly lift up securing spring to do so.
^
Loosen and remove locking cable from cable clip - 2 -.
Installing