Passat V6-2.8L (ATQ) (2004)
/Page-2036007.png)
^
Press ends of locking clip - B - together and remove.
^
Remove securing plate - A - for selector lever cable at selector mechanism downward.
^
Pull selector lever cable off selector lever.
^
Remove nuts (4 pieces) from above.
^
Remove selector lever mechanism housing downward.
^
Pull selector lever cable out of selector mechanism at the same time, do not bend selector lever cable while doing this.
Installing
^
Selector lever and lever/selector shaft in position "P" (park lock must engage).
^
Raise vehicle.
^
Shift the lever/selector shaft at the transmission in "P" position. Catch must engage in parking lock gear, both front wheels are locked (cannot be
turned together in one direction).
^
Slide boot of selector lever cable and cover for selector mechanism housing on selector lever cable.
^
Do not bend or kink the selector lever cable.
^
Guide selector lever cable into selector lever mechanism housing.
^
Attach selector lever mechanism housing to structure.
^
Tighten nuts (4 pieces) from above.
^
Connect electrical harness connectors.
^
Install and adjust locking cable.
^
Install cover.
^
Place selector lever in position "3".
^
Install selector lever handle.
^
Grease ball socket of selector lever cable with polycarbamide grease G052142A2.
^
Connect selector lever cable to selector lever.
Installation position:
Angled end of securing plate - A - points toward the end of the selector lever cable.
^
Install securing plate - A - for selector lever cable to selector mechanism housing.
^
Press ends of locking clip - B - together and slide onto the end of the selector lever cable.
^
Install cover. While doing this, note position of seal.
