Passat V6-2.8L (ATQ) (2004)
/Page-2057003.png)
^
Unscrew bolts - 2 - from bracket - arrow B -.
^
Unscrew bolts - 3 - from auxiliary ATF cooler - arrow A - and remove auxiliary ATF cooler.
Installing
^
Insert auxiliary ATF cooler - arrow A - and tighten bolts - 3 - for auxiliary ATF cooler.
^
Tighten bolts - 2 - for bracket - arrow B -.
^
Tighten bolts - 1 - from auxiliary ATF cooler - arrow A -.
^
Always replace O-rings - 1 -.
^
Coat O-ring - 1 - with ATF.
^
Make sure that O-rings are seated properly so that they do not slip out of their seating when connecting ATF lines.
^
Insert ATF lines - 2 - completely into auxiliary ATF cooler by hand to stop.
^
Only tighten bolts - 3 - when ATF lines are completely connected.
^
Then check ATF level and top off.
^
Check ATF line connections - 2 - for proper seal when checking ATF level.
^
Install cover for front bumper.
