Passat V6-2.8L (ATQ) (2004)
Continuation for all vehicles
-
Pull out clip -A- to stop using screwdriver to remove line/hose assembly.
Installing
Installation is performed in the reverse sequence. Note the following:
Note:
^
Brake fluid must not come in contact with the transmission. If necessary, clean the transmission housing.
^
To simplify assembly, select 6th gear before installing the slave cylinder.
^
Preload slave cylinder sufficiently so that the securing bolt can easily be inserted.
-
Lightly coat plunger surface contacting clutch release lever.
-
Coat area -a- of boot with lithium grease, G 052 150 A2, before installing slave cylinder in transmission housing.
Vehicles with 4-cylinder engine or 6-cylinder Diesel engine
-
Guide slave cylinder into mounting hole in transmission housing, without great sideways movement from working direction of plunger, and bolt
tightly.