Passat V6-2.8L (ATQ) (2004)
Slave cylinder plunger was probably inserted past clutch release lever.
Slave cylinder will be destroyed from a pedal pressure of approximately 300 N.
For comparison: Normal pedal pressure is approximately 115 N
^
Tighten bolt - arrow - to tightening torque.
^
For connection of hose/line assembly - B - to slave cylinder clip - A - must be pressed in until stop.
^
Insert hose/line assembly - B - into slave cylinder until line audibly engages.
^
Check by pulling hose/line assembly.
^
Bleed clutch system.
^
If removed, install exhaust pipe with catalytic converter and align exhaust system tension-free.
^
Install noise insulation panel below transmission.