Passat V6-2.8L (ATQ) (2004)
/Page-2119004.png)
^
Align clutch and brake pedal pivot pin so that it protrudes out of mounting bracket on clutch pedal side - arrow -.
^
Press clutch pedal until stop and insert over-center spring into mount on clutch pedal.
^
Place clutch pedal on pivot pin and push it to left until securing clip can be attached.
^
Connect master cylinder to clutch pedal and engage securing clip to clutch pedal.
^
Do not tighten bolt - arrow 2 - until both securing clips - arrow 1 - for clutch pedal, securing clip for brake pedal not depicted) for clutch and brake
pedal are attached on pivot pin.
^
Clutch Pedal Switch F36 adjusting.
Overview
Overview, 012/01W, 5 SPD. M/T
^
Obtain radio code for radios with anti-theft coding before disconnecting battery.
^
Disconnect battery Ground (GND) strap with ignition switched off.
^
If battery is re-connected, please note work after re-connecting battery.
^
Lubricate all bearing and contact surfaces with grease G 000 450 02.
^
Remove drivers side storage compartment before working on foot pedal assembly.
