Passat V6-2.8L (ATQ) (2004)
/Page-2119008.png)
Installing
Installation is the reverse of removal, noting the following:
^
Align clutch and brake pedal pivot pin so that it protrudes out of mounting bracket on clutch pedal side - arrow -.
^
Press clutch pedal until stop and insert over-center spring into mount on clutch pedal.
^
Place clutch pedal on pivot pin and push it to left until securing clip can be attached.
Connect operating rod/master cylinder to clutch pedal as follows:
^
Mount - A - must be located on operating rod - arrow - of master cylinder.
^
Insert mount into guide on clutch pedal and press clutch pedal toward bulkhead to engage, ensure correct engaging while doing so.
^
To check locking mechanism, pull clutch pedal slightly into passenger compartment and push both ends of mount toward clutch pedal using
screwdriver.
^
Do not tighten bolt - arrow 2 - until both securing clips - arrow 1 - for clutch pedal, securing clip for brake pedal not depicted) for clutch and brake
pedal are attached on pivot pin.
^
Clutch Pedal Switch adjusting.
