Passat V6-2.8L (ATQ) (2004)
/Page-2155002.png)
When attaching and removing assembly tool, do not damage propshaft protective coating.
^
Do not set alignment fixture 4W dr. shaft 3405 on balance plates.
^
Attach alignment fixture 4W dr. shaft 3405 and tighten plastic nuts.
Propshaft with nominal dimension 60 mm at front and 70 mm at rear
When attaching and removing assembly tool, do not damage propshaft protective coating.
^
Do not set alignment fixture 4W dr. shaft 3298 on balance plates.
^
Attach alignment fixture 4W dr. shaft 3298 with adapters 3139/3 and tighten plastic nuts.
Propshaft with nominal dimension 60 mm at front and 65 mm at rear
When attaching and removing assembly tool, do not damage propshaft protective coating.
The reduced diameter - arrow - can be disregarded.
^
Do not set alignment fixture 4W dr. shaft 3298 on balance plates.
^
Attach alignment fixture 4W dr. shaft 3298 with adapters 3139/3 and tighten plastic nuts.
Continued for all vehicles
In the following illustrations, adjustment of propshaft is depicted using alignment fixture 4W dr. shaft 3298. Adjustment of propshaft using alignment
fixture 4W dr. shaft 3405 is identical.
