Passat V6-2.8L (ATQ) (2004)
-
Lower vehicle.
-
Insert VAG 1869/2 brake pedal applicator.
-
Operate brake pedal using brake pedal applicator.
-
Raise vehicle.
-
At each constant velocity joint on driveshaft, remove lower three bolts.
-
Lower vehicle.
-
Remove VAG 1869/2 brake pedal applicator.
-
Raise vehicle.
-
Turn two rear wheels in same direction to move driveshaft 1/2 turn (180°).
-
Lower vehicle.
-
Insert VAG 1869/2 brake pedal applicator.
-
Operate brake pedal using brake pedal applicator.
-
Raise vehicle.
All vehicles
Driveshaft with 60 mm diameter housing front and rear
Note: Do not place the installation tool on balance pieces.
-
Insert 3405 installation tool and tighten plastic nuts.
Driveshaft with 60 mm diameter front housing and 70 mm rear housing
Note: Do not place the installation tool on balance pieces.