Passat V6-2.8L (ATQ) (2004)
/Page-2159002.png)
^
Threaded holes for bolts in drive flanges must always be cleaned. (e.g. using a tap)
6. Adjustment shim
^
Determining thickness
7. Nut, 25 Nm
8. Stud bolt, 10 Nm
^
Do not remove
9. Transmission
Driveshaft, Removing and Installing
Driveshaft, removing and installing, 01A, 5 SPD. M/T (AWD)
Special tools, testers and auxiliary items required
Alignment Fixture-4W Dr. Shaft 3139 with spacers 3139/3
Removing
^
Remove crossmember below exhaust system if installed.
^
Remove rear part of exhaust system from clamping sleeve(s).
^
Remove heat shields for driveshaft from body - arrows -.
^
Unbolt heat shield for driveshaft from cover for Torsen differential - arrows -.
