Passat V6-2.8L (ATQ) (2004)
-
Set to dimension -a- by moving selector mechanism.
-
Tighten push rod bolt (arrow) to prescribed torque.
-
Loosen selector rod bolt (arrow).
-
Connection of selector rod/selector mechanism must move freely.
Selector mechanism with limit stop pins of ball stop and mounting for spring (arrow)
-
Insert 14 mm hex key -A- between left tab (in direction of travel) (arrow -1-) of ball stop and sloped shoulder alongside ball stop (arrow -2-) and
hold.
-
Key must have contact along entire shoulder-2-.
-
Adjust gear selector lever so that it tilts slightly toward rear.