Passat V6-2.8L (ATQ) (2004)
/Page-2186003.png)
11. Hex nut, tighten to 10 Nm
12. Hex nut, tighten to 10 Nm
13. Cover
14. Hex nut, tighten to 25 Nm
15. Connecting piece
16. Hex nut, tighten to 25 Nm
17. Connecting piece
18. Circlip
^
Always replace
^
Remove before removing ball stop
19. Buffer
20. Ball housing
21. Shift lever bushing
22. Socket head bolt, 10 Nm
23. Socket head bolt, 25 Nm
24. Washer
25. Shift mechanism housing
26. Hex nut, tighten to 10 Nm
27. Hex nut, tighten to 10 Nm
^
Self-locking
^
Always replace
28. Shift fork
29. Bolt
30. Tensioning ring
31. Bellows
^
Before removing and installing, remove catalytic converter and front heat shield
Note:
^
Carefully pull bellows over shift rod
^
Place bellows on markings of shift rod and pivot rod
32. Shift rod
^
With shift coupling
33. Clamping piece
34. Socket head bolt, 25 Nm
35. Hex bolt, 23 Nm
^
Self-locking
^
Always replace
36. Socket head bolt, 40 Nm
37. Washer
^
Rounded side faces pivot rod
38. Washer
39. Pivot rod
Separate shift lever boot from shift knob
^
Turn inner side of shift lever boot toward outside.
^
Carefully push rib in - direction of arrow - using screwdriver; pull off shift knob while doing so.
