Passat V6-2.8L (ATQ) (2004)
^
With shift coupling
17. Hex bolt, 23 Nm
^
Self-locking
^
Always replace
18. Socket head bolt, 40 Nm
^
Cannot be removed from pivot rod bushing at front
19. Pivot rod
Shift Lever With Shift Lever Bearing, Removing and Installing
Shift lever with shift lever bearing, removing and installing, 01A, 5 SPD. M/T (AWD)
Removing
^
Carefully pry off shift lever boot from center console.
^
Remove knob with shift lever boot.
^
As of 1100, remove shift knob with shift lever boot.
^
Rubber cover for shift mechanism housing must be unscrewed - arrows -.
^
Remove mounting nuts - 1 - for shift mechanism housing.
This lowers shift mechanism housing.
^
Remove pivot rod, to do this unbolt socket-head bolts - 2 -.
^
Remove shift rod, to do this unbolt socket-head bolts - 3 -.
^
Loosen complete shift lever bearing from shift mechanism housing - arrows -.
^
Remove shift lever with shift lever bearing from shift mechanism housing.
Installing
Installation is in reverse order of removal. Note the following.