Passat V6-2.8L (ATQ) (2004)
Shift Interlock Solenoid: Service and Repair
01V, 5 SPD. A/T (AWD)
Shift Lock Solenoid N110, removing and installing, 01V, 5 SPD. A/T (AWD)
Removing
^
Remove selector mechanism.
^
Remove stop buffer - 2 - from cable lever.
^
Shift selector lever - 1 - into Tiptronic position and then remove frame - 3 -.
^
Place selector lever in position "2".
^
Disengage lever for locking cable - 4 - by lifting it out of its bearing and remove from selector mechanism housing - 5 -.
^
Press out pin for locking latch - 6 - using a drift.
^
Remove shift lock solenoid - 7 - together with locking latch - 6 - upward.
Installing
^
Place selector lever in position "2".
^
Shift lock solenoid - 7 - must be slid together with locking latch into the selector mechanism housing - 5 - from the top.
^
Carefully drive in pin for locking latch - 6 -.
^
Lay locking cable lever - 4 - into selector mechanism housing - 5 - and engage it noticeably in both bearing areas.
^
Set frame - 3 - onto selector mechanism housing (ribbing points upward) and insert buffer stop - 2 - into cable lever.
^
Install selector mechanism.