Passat V6-2.8L (ATQ) (2004)
NOTE: Resistance value is valid at approx. 20 degrees C. At higher temperatures, resistance value increases.
If one of the specified values is not obtained:
-
Replace the relevant solenoid valve.
-
Erase DTC memory of Transmission Control Module (TCM). Diagnostic mode 4: Reset/erase diagnostic data. See: Powertrain
Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic
Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and
Readiness Codes
If specified values are obtained:
-
Check wires to Transmission Control Module (TCM) according to wiring diagram.
Checking wires to Transmission Control Module (TCM)
-
Connect test box to Transmission Control Module (TCM) wiring harness. connect test box for wiring test. See: Powertrain
Management/Computers and Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/Test
Box, Connecting For Wiring Test
-
Check wires between test box and 16-pin connector to Transmission Control Module (TCM) for open circuit according to wiring diagram.
Wire resistance: max. 1.5 ohms
-
Also check wires for short circuit to each other.
Specified value: Infinite ohms
If no malfunctions are found in wires:
-
Replace Transmission Control Module (TCM) -J217-.