Passat 4Motion V6-2.8L (ATQ) (2005)
/Page-2595015.png)
Pulling out wheel hub
^
Install separating device - 1 - between wheel bearing housing and hub and pretension.
^
Installed location: Flat sides of plates face to wheel hub.
^
Install support - 2 -, hollow piston cylinder - 3 - with pull rod and special nut - 4 -.
^
Hold tool securely and pull out wheel hub.
1. Separating tool Kukko 17/2
2. Bell E-40
3. Hollow piston cylinder HKZ-15
4. Special nut E-8-214 and pull rod
5. High pressure hose with quick release coupling
Pulling out wheel bearing
^
Install press piece - 1 - with shoulder to bearing, press sleeve - 2 - with four stepped internal diameters to wheel bearing housing, hollow piston
cylinder - 3 - with pull rod and special nut - 4 -.
^
Operate pump and remove the wheel bearing.
1. Press piece E-5
2. Press sleeve E-44-1
3. Piston cylinder HKZ-15
4. Special nut E-8-214 and pull rod
Pulling off bearing inner race from hub
^
Install separating device - 1 - behind bearing inner race - 2 -.
