Passat 4Motion V6-2.8L (ATQ) (2005)
^
Install assembly device 3292 and tighten spindle.
The tool blades must be positioned exactly between the bonded rubber mounting collar and wheel bearing housing.
^
Insert pin 3293/1.
^
Install puller for wheel hub 3349 so that the blades slide exactly between bonded rubber mounting and wheel bearing housing.
^
Turn spindle - 2 - until the bonded rubber mounting lifts slightly off the wheel bearing housing.
^
Now tighten bolts - 1 -.
^
Install bridge 3292/2.
^
Press one of the bonded rubber mountings out by turning hex bolt - 1 -.
Pressing out second bonded rubber mounting
^
Insert thrust piece 3349/1 and use spindle from 3292.