Passat GLS L4-1.8L Turbo (AUG) (2001)
/Page-633003.png)
Continuation for all vehicles
-
Disconnect connector from Oil Level Thermal Sensor.
-
Mark installation positions for threaded assemblies -1- and positioning sleeves -2-.
-
Unbolt both engine mounts at bottom.
-
Install 10-222A engine support bridge as shown.
-
Remove eyelet for 2024A Engine Sling.
-
Insert bolt -1- in the center bore of 2024A Engine Sling and secure with a cotter pin.
-
Attach 2024A Engine Sling bolt to 10222A Engine Support Bridge spindle.
-
Attach 2024A Engine Sling to sling clamps at front and rear of engine.
WARNING! Take-up hooks and pins at engine sling must be secured using securing pins (arrows) as shown in illustration.
-
Lift up engine as far as possible using spindle of engine support bridge, or until the T-piece of crankshaft housing ventilation contacts the bulkhead
(approximately 20 mm).
-
Use 1202A engine hoist to support subframe.
