volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Campaign - Ignition Coil Replacement|Page 6466 > < Campaign - Ignition Coil Replacement|Page 6464
Page 9
background image

-

Unclip and remove lower cover -6- by sliding rearward out of clips

-

Using a volt meter, check the terminal contacts of the 15 amp fuse in position B -arrow- for 12 volts or B+ power) and make note of terminal
position in fuse housing
-

Under hood, remove battery cover and disconnect battery ground (GND) cable

-

Remove fuse/relay holders -A- and -C- (arrows) at the bottom of the lower relay panel

-

Remove fuse holder -B- from the bottom of lower relay panel -arrow- and remove fuse from holder

-

Remove (2) nuts -A- and pull lower relay carrier rearward and down to remove

-

Remove the B+ terminal (as previously found) from fuse holder B -arrow-

NOTE:  The illustration shows the wire removed from position #2, however, your vehicle could be different

-

Insert the B+ terminal (removed from fuse holder) into terminal housing -11- (191 972 751 or 1J0 972 751)

Campaign - Ignition Coil Replacement|Page 6466 > < Campaign - Ignition Coil Replacement|Page 6464