Passat GLS L4-1.8L Turbo (AUG) (2001)
-
Install press piece -1- with shoulder to bearing, press sleeve -2- with four stepped internal diameters to wheel bearing housing, hollow piston
cylinder -3- with pull rod and special nut -4-.
-
Operate pump and remove the wheel bearing.
1. Press piece E-5
2. Press sleeve E-44-1
3. Hollow-piston cylinder HKZ-15
4. Special nut E-8-214 and pull rod
Removing bearing inner race off hub
-
Install separating device -1- behind bearing Inner race -2-.
Installing position: Chamfer on plates faces to bearing inner race.
-
Install support -3- and hollow piston cylinder -4- with pull rod, screw on special nut -5- and remove bearing inner race.
1. Separating device Kukko 17/2
2. Bearing inner race
3. Support E-40
4. Hollow piston cylinder HKZ-15
5. Special nut E-8-214 and pull rod
Pressing in wheel bearing
Installation position: The larger internal diameter of the wheel bearing faces outward.