Passat GLS 4Motion V6-2.8L (ATQ) (2002)
Rear Door Window Regulator: Service and Repair
Window Regulator Motor or Assembly Carrier With Window Regulator, Removing and Installing
Window Regulator Motor Or Assembly Carrier With Window Regulator, Removing And Installing
Removing
NOTE: Illustration shows removal and installation of window regulator motor/assembly carrier with window regulator on rear doors. procedure for
removing and installing on front doors is same.
Removing front or rear assembly carrier.
-
Slide a hammer handle between window channel and SF so far until hammer handle end presses on gears of SF.
-
Remove bolts - 1 - and remove window regulator.
Installing window regulator motor
-
By removing window regulator motor, gearing shifts, it is not centered.
-
When installing window regulator motor, gears must be aligned until window regulator motor is centered again.
-
Attach and tighten bolts - 1 -, tightening torque: 3.5 Nm.
tightening torque must always be observed since otherwise damage to plastic sleeve on window regulator motor can result.
Installing assembly carrier with window regulator