Passat GLS 4Motion V6-2.8L (ATQ) (2002)
^
Remove protective seal using 3409 wedge.
^
Remove seal using 3409 wedge.
Note: When removing make sure that the surface of the cylinder is not damaged.
Installing
^
Clean surfaces of the piston and seal (use only appropriate solvent) then dry.
^
Apply a thin coat of paste G 052 150 A2 to piston and seal before installing.
^
Install oil seal in brake caliper housing.
^
Place the outer sealing lip of protective seal on the piston.
^
Using 3409 wedge, insert the inner sealing lip into the grove in the cylinder.