Passat GLS 4Motion V6-2.8L (ATQ) (2002)
-
Remove workshop crane V.A.G 1202/A, swing stabilizer bar down.
-
Remove lower part of oil pan.
Engines with oil pump with chain drive
-
Remove oil pump.
Continued for all engines
-
Remove engine/transmission bolts in area of upper part of oil pan.
-
Remove bolts - 1 - for upper part of oil pan.
-
Press upper part of oil pan from alignment pins of cylinder block.
-
Remove upper part of oil pan.
Installing
Installation is performed in reverse order of removal. Note the following.
Note: Always replace self-locking nuts, gaskets and seals.
Upper part of oil pan with solid gasket
-
Before installing, clean sealing surfaces of upper part of oil pan.