Passat GLS 4Motion V6-2.8L (ATQ) (2002)
/Page-379002.png)
-
Loosen hex bolts -1-, -2-, -5-, -6-, -7 and -8-.
-
Turn bolt -2- until the specifications are achieved.
Refer to Alignment; Specifications.
-
Relieve tension on bolt -2- and check the readings obtained, if necessary correct camber again.
-
Screw in new hex bolts -7- and -8-.
-
Remove camber adjustment device -VAG 1941-.
-
Screw in new front hex bolts -5- and -6- and tighten
-
Tighten new hex bolts -1-, -2-, -3- and -4-.
Important: The toe must be checked after each camber adjustment.
