Passat GLS 4Motion V6-2.8L (ATQ) (2002)
Specified value: 17.5 to 19.5 Ohms
If specified values are not obtained:
-
Replace Leak detection pump (LDP) -V144-
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If specified values are obtained:
-
Connect test box to control module wiring harness, connect test box for wiring test. See: Computers and Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box, Connecting For Wiring
Test
Vehicles with engine code AHA
-
Check wires between test box and 3-pin connector for open circuits according to wiring diagram.
Terminal 1 + socket 37
Terminal 2 + socket 16
Wire resistance: max: 1.5 Ohms
Vehicles with engine code ATQ
-
Check wires between test box and 3-pin connector for open circuits according to wiring diagram.
Terminal 1 + socket 80
Terminal 2 + socket 25
Wire resistance: max: 1.5 Ohms
Continuation for all vehicles
-
Also check wires for short circuits to each other, to vehicle Ground (GND) and to B+.
Specified value: Infinite Ohms
-
Check wire between 3-pin connector terminal 3 and the Fuel Pump (FP) Relay -J17- for open circuit according to wiring diagram.
Wire resistance: max: 1.5 Ohms
If no malfunctions are found in wires:
-
Replace Motronic Engine Control Module (ECM) -J220-.