Passat GLS 4Motion V6-2.8L (ATQ) (2002)
/Page-1825011.png)
Pulling in front bonded rubber mounting
-
Coat bonded rubber mounting with e.g. tyre assembly paste.
-
Insert segments -3372/2- in tube -3372-
-
Pull in mounting -A- until the thrust piece -3372/1- aligns with the upper edge of tool -3372-.
Continued
-
Lift tube -3372- and remove segments -3372/2-.
-
Replace bridge -3351/4- with thrust piece -3351/1 and then push mounting in onto stop.
Threads In Longitudinal Member
Threads in longitudinal member, servicing
It is possible to service the threads in the nuts welded in the longitudinal member depending on certain conditions.
^
Servicing work may only be carried out once per thread.
^
If servicing is necessary after this, the nuts must be replaced.
^
Observe the operating instructions of the VAS repair kit.
WARNING: When drilling, it is essential that eye protection be worn!
^
Have your work checked by the foreman responsible or person next in charge.
^
Correct any damage to the underbody sealant layer.
^
Only use the VAS repair kit listed in the table for servicing work
