Passat GLS Wagon V6 V6-2.8L (ATQ) (2001)
/Page-1833001.png)
Brake Master Cylinder: Service and Repair
Removing and Installing
Special tools and workshop equipment required
^
3320 Door adjusting wrench
Removing
^
Place sufficient lint free cloths in area of plenum chamber, engine and transmission.
^
Install bleeder hose and bleeder bottle to the front left brake caliper bleeder screw and open bleeder screw.
^
Operate brake pedal until sufficient amount of brake fluid has been pumped out for the brake fluid level in the brake fluid reservoir to sink below
the supply hose.
^
Close front left bleeder screw.
^
Disconnect off clutch master cylinder supply hose -1- and seal with a plug.
^
Disconnect connector off float warning indicator sensor -2-.
^
Remove bolt -3-.
^
Remove brake fluid reservoir -4-. To do this press down the locking tab on the reservoir and at the same time pull the brake fluid reservoir out of
the sealing plugs.
^
Disconnect brake lines -1- on brake master cylinder and seal brake lines and threaded holes with plugs from repair kit Part No. 1 HO 698 311 A.
