Passat GLX V6 V6-2.8L (ATQ) (2001)
-
Unclip trim - 1 - from B-pillar at sides first, then in upper area.
-
Remove seatbelt - 2 - from trim.
Installing
-
Check clips - 1 -, replace if necessary and insert into mounts of trim - 2 -.
-
Guide seatbelt with tab and belt end fitting through trim.
-
Place trim in installation position and clip onto B-pillar, make sure seatbelt height adjuster is seated properly.
-
Bolt belt end fitting onto sill (40 Nm).
-
Clip door sill trim.
-
Install lower A-pillar trim.
-
Make sure that door seals are properly seated.
Vehicles with head-level airbag
NOTE: Upper B-pillar trim must be replaced after removal as it cannot be removed without being destroyed.