Passat GLX V6 V6-2.8L (ATQ) (2001)
^
Clean if reusing
3 - Guide pin, 25 Nm
4 - Cap
^
Insert in mounting bush
5 - Mounting bush
^
Insert into brake caliper housing
6 - Brake caliper housing
^
7 - Bleed valve
^
Apply thin coat of assembly paste G 052 1 50 A2 to threads before screwing in
8 - Protective cap
^
Push onto bleed valve
9 - Retaining spring
^
Insert with both ends in the brake caliper housing holes and then press under the brake carrier
10 - Protective - seal
^
Do not damage when installing piston
11 - Piston
^
Apply a thin coat of paste G 052 1 50 A2 to piston before installing
12 - Seal
Front brake caliper piston, removing and installing
Special tools and workshop equipment required
^
3409 Wedge
^
Piston resetting tool
Removing
^
Force piston from brake caliper housing using compressed air.
Note:
^
Place a wooden board in the recess of the caliper housing to prevent damaging the piston.
^
Only one piston at a time can be forced out. When doing this hold the other piston in the caliper using the piston resetting tool.