Passat GLX V6 V6-2.8L (ATQ) (2001)
-
Remove ATF inspection plug from oil pan (arrow).
ATF drips out of drilling:
ATF level -arrow- is OK.
Only a small amount of ATF should come out of the inspection hole when the engine is running.
-
Fit new O-ring on ATF inspection plug and tighten to 80 Nm. The ATF check is now completed.
-
Switch off engine.
If no ATF comes out of the inspection hole: Top up ATF as described below.
ATF, Topping Up
With engine running.
-
Guide VAG 1924 in through an opening -arrow- in the deflector cap, taking care not to push the deflector cap upward out of position.
-
Fill with ATF using VAG 1924 -arrow- until ATF comes out of inspection hole.