Passat GLX V6 V6-2.8L (ATQ) (2001)
/Page-580010.png)
-
Remove nut -1-, take out hex bolt and remove both links -2- out upward.
The slits in the wheel bearing housing must not be widened using a chisel or similar tool!
If the hex bolt cannot be removed from the wheel bearing housing, then the hex bolt and the links -2- must be pressed out of the wheel bearing
housing.
-
Remove hex bolt for drive shaft.
-
Swing wheel bearing housing out of the way.
-
Remove drive shaft from wheel bearing housing and tie up.
Note: Place transmission jack VAG 13831A underneath (danger of accident from falling parts when removing the wheel hub and the wheel
bearing).
Removing hub
-
Install separating device -1- between wheel bearing housing and hub and pretension.
Installation position: Flat sides of plates face to wheel hub.
-
Install support -2-, hollow piston cylinder -3- with pull rod and special nut-4-.
-
Hold appliance firmly and remove wheel hub.
1. Separating device Kukko 17/2
2. Bell E-40
3. Hollow piston cylinder HKZ-15
4. Special nut E-8-214 and pull rod
5. High pressure hose with quick release coupling
Removing wheel bearing
