Passat GLX V6 V6-2.8L (ATQ) (2001)
Continuation for all vehicles
If specified value is not obtained:
-
Measure resistance for sensor heater at connector to oxygen sensor terminal 1 + 2.
Specified value: max: 200 Ohms
-
Replace the respective oxygen sensor:
-
Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) -G130-, bank 1, item 4
-
Oxygen Sensor (O2S) 2 Behind Three Way Catalytic Converter (TWC) -G131-, bank 2, item 11
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If specified value is obtained:
-
Check Ground (GND) activation of the respective oxygen sensor heater.
-
Connect test box to control module wiring harness, connect test box for wiring test. See: Computers and Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box, Connecting For Wiring
Test
-
Check wires between test box and 4-pin connector to Engine Control Module (ECM) for open circuit according to wiring diagram.
Wire resistance: max: 1.5 Ohms
Vehicles with engine code AHA
Vehicles with engine code ATQ