Passat GLX V6 V6-2.8L (ATQ) (2001)
Shift Interlock Solenoid: Service and Repair
Shift lock solenoid -N110-, removing and installing
Removing
-
Remove shift mechanism.
-
Remove stop buffer -2- from cable lever.
-
Shift selector lever-1- into Tiptronic position, then remove frame -3-.
-
Shift selector lever into position "2".
-
Lift lever for locking cable -4-, detach from mounting and remove from mounting bracket -5
-
Drive out fulcrum pin for locking pawl -6- using punch.
-
Remove shift lock solenoid -7- together with locking pawl -6- upward.
Installing
Shift selector lever into position "2".
-
Shift lock solenoid -7- must be installed together with locking pawl from above in mounting bracket -5-.
-
Carefully drive in pin for locking pawl -6-.
-
Place lever for locking cable -4- in mounting bracket -5- until detents can be felt to engage in both mounting positions.
-
Place frame -3- on mounting bracket (reinforced side upward) and insert stop buffer -2- in cable lever.
-
Install shift mechanism.