Passat GLX V6 V6-2.8L (ATQ) (2001)
/Page-1685004.png)
1. Hex key head bolt, 25 Nm
2. Heat shield
3. Circlip
^
Always replace
^
Remove and install with VW 161 a
4. Gasket
^
Replacing. Pull off protective foil and stick onto joint.
5. Inner constant velocity joint
^
Outer diameter 100 or 108 mm depending on engine/transmission combination
^
Only replace complete
^
Pressing off see Fig. 3
^
Pressing on see Fig. 4
6. Drive shaft (tube shaft)
7. Hose clip
^
Always replace
8. Protective boot
^
Check for tears and chafing
9. Hose clip
^
Always replace
^
Tensioning see Fig. 1 and Fig. 5
10. Dished washer
^
Outer diameter (concave side) contacts thrust washer
11. Thrust washer
12. Circlip
^
Always replace
^
Insert in shaft groove
13. Outer constant velocity joint
^
Only Replace complete
^
Removing see Fig. 2
^
Installing: drive onto shaft on to stop with plastic hammer
14. Hex bolt
