Passat GLX V6 V6-2.8L (ATQ) (2001)
-
For rear slide rod to shift lever housing
3. Hexagon socket head bolt, 25 Nm
4. Washer
5. Hexagon socket head bolt, 25 Nm
6. Clamping piece
7. Hexagon nut, 10 Nm
-
Qty. 4
-
For shift lever housing to body
8. Hexagon nut, 10 Nm
-
Self-locking
-
Always replace
9. Shift lever
10. Spacer tube
11. Selector fork
12. Bolt
13. Shift lever housing
14. Tensioning ring
15. Bellows
-
Remove catalyst and front heat shield before removing and installing
Notes:
-
Carefully pull bellows over selector rod
-
Place bellows on the marks on selector rod and push rod
16. Selector rod
-
With selector joint
17. Hexagon bolt, 23 Nm
-
Self-locking
-
Always replace
18. Hexagon socket head bolt, 40 Nm
-
Cannot be removed from front slide rod bearing bush
19. Front push rod
Shift lever with rear slide rod, removing and installing
Removing
-
Carefully lever the cover off the center console.
-
Then unscrew the shift lever knob with cover.
-
The rubber cover for the shift lever housing must be removed (arrows).