Passat Sedan L4-1.9L DSL Turbo (AAZ) (1995)
Crankshaft Main Bearing: Testing and Inspection
LEGEND
1
Bearing Shells No. 1, 2, 4 and 5
2
Main Bearing Cap Bolts
3
Main Bearing Cap
4
Bearing Shell No. 3
5
Upper Main Bearing Thrust Washers
6
Sensor Wheel
7
Bolt
8
Dowel Pin
9
Crankshaft
10
Lower Main Bearing Thrust Washers
NOTE: During testing procedures, refer to the component location illustration above and component notes below.
COMPONENT NOTES
Main Bearing Cap Bolts (2)
-
Tighten only to 65 Nm (48 ft. lbs.) when checking clearances.
Main Bearing Caps (3)
-
Bearing cap 1 installed at pulley end.
-
Bearing cap 3 with recesses for thrust washers.
-
Bearing shell retaining lugs of cylinder block and bearing cap must be on the same side.
Bearing Shell No. 3 (4)
-
Shells without oil groove installed in bearing caps.
-
Shells with oil groove installed in block.
-
Do not interchange used bearings.
Upper Main Bearing Thrust Washers (5)
-
Install on bearing cap No. 3.
-
Refer to illustration for installed position.
Crankshaft (9)
-
Check Crankshaft Axial Clearance: