Passat Sedan L4-1781cc 1.8L DOHC Turbo (ATW) (2000)
^
Do not damage/bend when assembling
10. 10 Nm
11. Sealing flange with oil seal
^
Only replace complete
^
Lightly oil sealing lip of oil seal
12. Oil seal
^
Replacing, Refer to Engine.
13. Intermediate shaft
^
Axial clearance max. 0.25 mm
14. O-ring
^
Replace if damaged
15. Sealing flange intermediate shaft
Drive plate, removing and installing
Special tools and equipment
^
Counter-hold tool VW 558
^
Hex bolt M8 x 45 and two M10 hex nuts
^
Depth gauge
Loosening and tightening drive plate
-
Secure counter-hold tool VW 558 to drive plate with hex bolt M8 x 45. Place two M10 hex nuts between counter-hold tool and drive plate.
Position of counter-hold tool:
A - To loosen
B - To tighten
Installing drive plate