Passat Sedan L4-1781cc 1.8L Turbo (AEB) (1999)
/Page-677003.png)
Note: Implementation of PTFE seals (identifying characteristics: without spring, sealing lip extends further). The sealing lip of these seals must not
be oiled or lubricated.
-
Remove residual oil at camshaft pins using a clean rag.
-
Position guide sleeve T10071/1 on camshaft pins.
-
Slide seal over guide sleeve.
-
Press in seal up to stop using 3241/1 seal installer. Use 3241/5 hex bolt for this.
The remainder of the installation is in the reverse order of removal.
Installing toothed belt and adjusting timing, Refer to Timing Components.
Camshaft position sensor seal, removing
