Passat Sedan L4-1781cc 1.8L Turbo (AEB) (1999)
-
Unbolt impeller housing -1- from pump housing -4-.
Installing
Installation is the reverse of removal, noting the following:
-
Clean sealing surfaces of both housings.
-
Replace gasket and O-ring.
-
Insert T-head bolt into coolant pump bore.
-
Mount bracket for generator, power steering pump and viscous fan with coolant pump on cylinder block and tighten bolts to 30 Nm in numerical
sequence.
1. Tighten bolt -A
2. Tighten bolt -B
3. Tighten bolt -C
4. Tighten bolt -D
5. Tighten bolt -E
6. Tighten bolt -F
-
Install viscous fan See: Cooling System/Radiator Cooling Fan/Fan Clutch/Service and Repair
-
Install ribbed belt See: Drive Belts, Mounts, Brackets and Accessories/Ribbed Belt/Service and Repair/Procedures
Note:
When installing ribbed belt, check for correct seating on belt pulley.
-
Install V-belt See: Drive Belts, Mounts, Brackets and Accessories/Ribbed Belt/Service and Repair/Procedures
-
Fill up with coolant See: Cooling System/Coolant/Service and Repair