Passat Sedan L4-1781cc 1.8L Turbo (AEB) (1999)
/Page-1075002.png)
NOTE: If the Control Module Basic setting is interrupted, the cause could be one of the following:
-
Throttle cannot reach mechanical stop because of contamination e.g. oil deposits or an incorrectly adjusted throttle cable.
-
Battery Voltage too low.
-
Throttle Body Control Module or wiring is faulty.
After an abort, DTC "17967" is stored in DTC memory. When next switching ON the ignition Basic setting is automatically performed again.
-
End engine basic setting at the earliest after 30 seconds by pressing -> button.
-
Press 0 and 6 buttons to select Function 06: "End data transfer"
-
Press Q button to enter input
