Passat Sedan L4-1781cc 1.8L Turbo (AEB) (1999)
Control Module: Service and Repair
5 Speed Automatic 01V
Removing Automatic Transmission Control Module -J217-
Removing automatic transmission control module -J217-
-
Loosen carpet and fold up.
-
Unclip control module from box -arrows-
-
Release multi-pin connector, then pull connector off control module.
Installing Automatic Transmission Control Module -J217-
Installing automatic transmission control module -J217-
-
Place multi-pin connector on transmission control module connector housing -1-, swing in -2- and lock -3-.
Code control module (function 07)
Code control module (function 07)
NOTE:
-
All functions that were previously performed using the VAG1551 Scan Tool (ST) can now be performed with the VAS5051.
-
If the correct coding for the vehicle is not indicated or if the Transmission Control Module (TCM) -J217- was replaced, then the control module
must be replaced:
-
Do not start engine!
-
Place selector lever in position -P-.
-
Connect VAG1551 Scan Tool (ST), enter address word "02 Transmission Electronics" and continue until "Select Function XX" is indicated on
display from See Page 01-31.
Coding is only possible if the Workshop Code (WSC) has been entered in the VAG1551.
Indicated on display